Crystal Clear Table Top Epoxy Resin Quart Kit | Great for Wood projects Bar Tops River tables Tumblers Artist Quality| Two part Kit includes Resin and Hardener

FEATURES: Clear gloss finish – Free from "sweat out" or exudation. 100% solids – contains no solvents or volatile’s.
Tough, resilient coating with negligible shrinkage.
Can be pigmented any color.
Strong adhesion to wood, metal, concrete, fiberglass, foam, etc.
Good chemical resistance
USES: High build coating for bars, tabletops, decorative panels, coating Styrofoam, etc.
MIXING RATIO: Mix equal parts by volume of Part 1 Resin and Part 2 Hardener. MIX VERY THOROUGHLY to insure that all of the resin and hardener are completely combined together
POT LIFE: 25 minutes @ 72?F. Higher temperatures shorten pot life . Thin film set – 4 hours @ 72?f.
COVERAGE: 12 sq. ft. per mixed gallon
APPLICATION: Surface should be clean, dry and sanded. Apply in two coats. The first coat is a thin sealer coat to prevent any air from coming from the wood and causing bubbles. This coat is usually 1 millimeter (.04 inches) thick. The second coat is the finish coat. It should be applied thick enough to produce a smooth surface. This should take approximately 3 millimeters (.12 inches) of epoxy.
Air bubbles can come from a porous surface. They come up from tiny holes in the surface after the epoxy is poured. The solution is to apply a thin coat of 39 on the surface to seal it. After the coat dries, proceed with the rest of the application process. Air bubbles are created in the epoxy liquid when the two parts are mixed together. These bubbles appear immediately in the surface after it is poured. The solution is to heat the surface with a propane torch moved over the surface from a distance of about (12 inches). The heat will thin the epoxy surface and release the bubbles. It can also come from pouring the epoxy too thick in one pour. We recommend no more then an 1/8".